LC- SOLID FILM LUBRICANT
HEAT CURING
SERIES V LEAD FREE
MEETS SAE SPEC ASC TYPE I (FORMERLY MIL-L- TYPE I)
DESION
Sandstrom LC- Dry Film Lubricant is a lead free lacquer-like
coating containing molybdenum disulfide and corrosion-inhibiting
pigments. This Heat Curing material prevents corrosion, galling,
seizing, and fretting. It is a low-friction coating which exhibits long
wear life when operated at -oF to +oF under loads exceeding
, psi.
LC- should be applied in place of Sandstrom A where
maximum wear life and corrosion protection from a dry film lubricant
are required on metals which may be adversely affected by
A's hour @ oF bake cycle.
Once Sandstrom LC- has been heat cured, it is virtually
unaffected by atmospheric and fretting corrosion, solvents, acids,
oils, and degreasers, and is not resoftened again at elevated
temperatures.
LC- may be applied to a wide variety of surfaces by spraying or
dipping. Complete application instructions are on the reverse of
this sheet.
OUTSTANDING FEATURES/BENEFITS
Excellent Corrosion Protection, Chemical Resistance, and Long
Wear Life are its outstanding characteristics.
SANDSTROM LC- CONTAINS NO LEAD OR GRAPHITE
TYPICAL USES
Sandstrom LC- is an excellent solution to the problem of
lubricating parts:
? Where "clean operation" is desired (LC- will not collect dirt and
debris as do grease and oils)
? Where parts may be subjected to frequent disassembly
? Where a protective coating and sacrificial break-in lubricant are
needed
? Where fretting and galling is a problem (such as splines, universal
joints, and keyed bearings)
? Where easy release is desired (such as acme nuts and screws
and PVC molds)
? Where metallurgical properties are adversely affected by baking
at temperatures higher than oF
? That will be operated in corrosive atmospheres
? That may be stored for long periods
? Which are seldom lubricated once they leave the factory and
where permanent lubrication is desired
? Where operating pressures exceed the load-bearing capacities of
ordinary oils and greases
COMPOSITION AND PHYSICAL PROPERTIES
Net Weight per gallon . lbs + . lb
Solids content .% + %(By Wt.)
Viscosity - sec / # Zahn
Flash point oF + oF Setaflash
Operating temperature
range -oF to +oF
Wear life minutes average,新供应信息-尽在五金商机网
如因作品内容、版权和其它问题需要同本网联系的，联系邮箱：pitechan@foxmail.com。